Polisher-Control/docs/09-acceptance-checklist.md

Acceptance Checklist

This checklist condenses the current P11 firmware/control spec for implementation tracking.

Input contract

• Accepts controller-job.v1 only.
• Rejects job.v1 and malformed input.
• Runs 4-gate intake validation.
• Rejects wrong machine_id.
• Rejects incompatible controller_version or unsupported capability.

Execution

• Sequential segment execution exists for future job mode.
• Force PID tracks setpoint within agreed commissioning tolerance.
• Force modulation uses live table encoder angle.
• Table and spindle RPM follow commands.
• Pause time excluded from segment polishing time.

Telemetry

• Core channels logged at >=100 Hz.
• Single monotonic timestamp source.
• Commanded and actual values both present.
• Sensor faults are detectable.
• CSV parseable by standard tools.

State machine and safety

• All accepted states/transitions implemented.
• Illegal transitions logged.
• Operator acknowledge cannot be bypassed.
• E-stop all-stop independent of software state.
• Interlocks implemented with documented thresholds.
• Watchdog timeout causes pause, then abort.
• FAULTED exits only through explicit reset.

Manual mode

• MANUAL reachable from IDLE.
• Live setpoint adjustment works.
• Geometric gate blocks stale geometry.
• Setpoint changes are timestamped events.
• Manual-session log emitted on exit.
• Safety behavior identical to job mode.

Data

• /data/manual/{session_id}/ and /data/runs/{run_id}/ layouts respected.
• status.json maintained.
• Hashes/manifests emitted.
• Raw telemetry preserved during commissioning.